Rear Panel Accessibility
Step: 2
Remove the screw which
is fitted with the Inlet Air
Duct. (See Fig. 2)
Step: 3
Remove the Gas Pipe
screws (1, 2) which is fitted
with the Base Panel. (See
Fig. 3)
Step: 4
Remove the screw (1) (See Fig.4) that affixes the
Gas Pipe Inlet with the Base Panel and release the
connector (2). (See Fig. 5)
Fig. 4
Fig. 1
From Heater Assembly, we can access the following
components:
1.
Flame Sensor
2. Burner Assembly
3. Igniter
4. Inlet Thermal Limiter (Accessibility same as
Electrical Model)
5. High-Limit Thermostat (Accessibility same as
Electrical Model).
Fig. 2
Flame Sensor
11.7.1 Flame Sensor Accessibility
Fig. 3
Remove the screw (1) of Flame Sensor which fits with
Heater Assembly as shown in Fig. 6 and also remove
the clamp (2) as shown in Fig. 7.
Fig. 5
32
Burner Assembly
Fig. 6
Fig. 7