Electrolux EFME617SIW Service Manual page 43

Diagnostic System (For Models 617, 517 and 417 Series)
Code Full Name
User Interface
91
Communication
User Interface Protocol
92
Incongruence Error
Machine Configuration
93
Checksum Error
Cycle Configuration
94
Checksum Error
Missing Program on CTF
97
Error
User Interface
9C Configuration Checksum
Error
User Interface Touch
9E
Sensor Not Working
Power Supply Frequency
H1
Out of Range
Power Supply Amplitude
H2
Out of Range
Power Supply Amplitude
H3
Out of Range
H4 Line Wiring Error
Line Safe Relay Short
BD
Circuit Error
BE Line Safe Error
BF Line Safe Sensing
F1 Ventilation Blocked
F6 Safety Reset Error
1. Wiring Failure
2. User Interface Board Failure
Error
3. Main Board Failure
The User Interface mounted is not compatible with
the Main Board connected.
Wrong Machine Configuration File
Wrong Cycle Configuration File
1. Wrong selector configuration (MCF)
2. Missing cycle on cycle table (CCF)
Software problem between Main Board and User
Interface Board.
One or more touch buttons have calibration
problems.
1. Electrical Noise
2. Humidity / Water on UI Board
3. UI Board Defective
1. Power Supply Problems
2. Wrong MCF
3. Main Board Failure
1. Power Supply Problems - Too HIGH VOLTAGE
2. Wrong MCF
3. Main Board Failure
1. Power Supply Problems - Too LOW VOLTAGE
2. Wrong MCF
3. Main Board Failure
Wrong Line Wiring / Connection
Line Safe Relay Problem (Main Board Failure)
Line Sage Relay Problem (Main Board Failure)
Error Line Safe Sensing Circuit Failure (Main Board Failure)
Air Flow Duct clogged or blocked, remove debris,
Error
clean and check one way Vent operation.
Main Board Fault
Notes and Possible Causes
43
User
Page
Interface
No.
Notification
No 53
No 53
Yes 53
Yes 54
Yes 54
Yes 54
No 54
Yes 55
Yes 55
Yes 55
Yes 55
No 56
No 56
No 56
Yes 56
No 57