Setup Function; 1-Mig And Pulsedmig Synergic Curves - Kemppi PRO EVOLUTION MXE Operation Instructions Manual

Use of stored welding situations, ON
a) Select ON (9).
b) Select the memory channel with CH- and CH+ keys.
c) Weld and carry out if necessary fine control for voltage/arc length from panel potentiometer (5)
or from remote control in case you have selected remote control mode (7).

2.2.6. SETUP function

With SETUP function users can change many of such MIG, 1-MIG and PulsedMIG welding para-
meters, for which there is no own adjustment on the panel. They can also be changed in ON and SET
mode of the memory function. Such parameters are for example pre and post gas times and hot-start.
With SETUP key (14) user can choose to use either factory parameters (FACTORY) or parameter
values changed by himself (USER). You can change the parameters in change state. To go over to
change state and return from it is done by pressing two keys simultaneously (11 and 14), see picture.
Control panel keys, which have function in SETUP mode are marked with blue color. Functions
of SETUP mode: S = parameter selection, +/- = value adjustment up/down, M = parameter value
storing into memory.
11

2.2.7. 1-MIG and PulsedMIG synergic curves

Synergic PulsedMIG
Synergic MIG/MAG
MIG process selection
The MXE panel includes factory curves/programs for synergic welding of the most common
materials. The factory curve is selected from selection block (10), where you first select mate-
rial, then gas and after that wire diameter, all these depending on filler wire and shielding gas
type you are using. Material selection is divided into 4 groups. Fe group: iron-based filler wires,
Al group: aluminium-based filler wires, Ss group: stainless filler wires and X group: special
wires. Synergic welding functions are marked with red colour. Enclosed tables for 1-MIG and
PulsedMIG synergic curves:
© KEMPPI OY
Activation of change state and return to welding state by
pressing two keys simultaneously (11 and 14).
14
S, parameter selection
M, storing into
memory
+/- , value adjustment
Wire diameter selection / display
Moving back and forth in
SETUP functions
10
Material selection
Material display
Gas selection / display
Display of synergic
curve number
KEMPPI PRO EVOLUTION, MXE / 0547 – 7