Henny Penny CFE-410 Technical Manual page 27

3-5. DAILY FILTERING
(CONTINUED)
Figure 3
Figure 4
Jan. 2013
8. Scrape or brush the sides and the bottom of the vat. Be careful
not to damage the sensing probes.
Do not use steel wool, other abrasive cleaners or cleaners/
sanitizers containing chlorine, bromine, iodine or ammonia
chemicals, as these will deteriorate the stainless steel material
and shorten the life of the unit.
Do not use a water jet (pressure sprayer) to clean the unit,
or component damage could result.
9. Once the vat is clean and the display shows "SCRUB VAT
COMPLETE?" "YES NO". Press
shows "WASH VAT" "YES NO".
10. Press √ button, display shows "WASHING" and oil circulates
through vat for several minutes. When wash cycle is complete,
display shows "WASH AGAIN?" "YES NO".
11. Press button if another wash is needed, otherwise press
button and the display shows "CLOSE DRAIN". Push-in on
drain knob to close drain (Figure 3), the display shows
"RINSING" and vat fills with oil.
12. Once the vat is filled, "OPEN DRAIN" shows in display. Pull-out
on drain knob to open the drain (Figure 4) and display shows
"RINSING". When rinsing is complete, display shows "RINSE
AGAIN?" "YES NO".
13. Press button if another rinse is needed, otherwise press
button. Display shows "POLISH?" "YES".
14. Press button for YES and oil is "polished" by circulating
it through the filtering system. The display shows "5:00
NO=STOP". If desired, press
otherwise the oil is polished for 5 minutes.
15. Once the oil is polished, the display shows "FILL VAT?" "YES".
Press button and display shows "CLOSE DRAIN". Push-
in on drain knob to close drain (Figure 3), display shows
"FILLING" and vat then re-fills with oil.
3-5
button and the display
button to stop the polishing,