Craftsman 113.298141 Owner's Manual page 17

11. Lift motor and insert the TWO PINS on motor base
into HOLES in cradle ... push motor in as far as it will
go.
12. Lower the blade...install belt on saw pulley and motor
pulley.
13. Sight along edges_ of both pulleys arid move motor
pulley so that belt is parallel to the edges of both
pulleys...tighten the setscrew in the motor pulley.
14. IMPORTANT: Measure the distance from end of motor
shaft to pulley...mark this dimension down; you will
need it later when reinstalling the pulley.
15. Make sure blade is 90° to table...raise i_ all the way
up.
16. Lift motor until edge of washer is even with end of slot
... tighten pivot screw. In this !_osition, pull motor
toward you (pins will slide out of cradle) until belt is
TIGHT ... tighten the two MOTOR BASE CLAMP
SC REWS.
17. Loosen Pivot Screw slightly.
18. Lower the saw blade all the way down.
19. IMPORTANT; Motor should pivot freely downward as
blade is lowered. If it does not, LOOSEN the PIVOT
SCREW some more.
20. Pivot screw must be adjusted only tight enough to allow
motor to pivot FREELY as blade is raised or lowered,
This will maintain constant tension on belt.
EDGE OF WASHER
EVEN WITH END
OF SLOT
MOTOR PULLEY
MOTOR BASE
CLAMP SCREWS _
21. Loosen the two MOTOR CLAMP SCREWS on each end
of motor. Rotate the motor so that the CAPACITOR
COVER is on top...tighten the screws.The ventilation
holes are now facing downward which will help prevent
sawdust from entering motor,
CAPACITOF
COVER
\
VENTILATION
HOLES
\
MOTOR
CLAMPSCREW
(BOTH ENDS)
17
/