Assembly; Installation; Safety Instructions; Safety Instructions: Explosion-Proof Machines - Siemens SIMOTICS SD Operating Instructions Manual

Assembly

5.1

Installation

5.1.1

Safety instructions

Risk of burning
Electrical machines have hot surfaces.
Fatal or severe injuries and substantial material damage can occur if the required covers
are removed or if the machines are not handled, operated, or maintained properly.
• Allow the machine to cool down before starting any work on it.
• Only remove covers in compliance with the applicable regulations.
• Operate the machines properly.
• Prevent parts (cables, etc.) from coming into contact with the machine enclosure.
NOTICE
Damage to the motor
In order to avoid material damage, check the following points before commissioning the
motor.
• Using appropriate measures, check whether the correct direction of rotation of the motor
• Ensure that temperature-sensitive parts (cables, etc.) are not in contact with the
• Ensure that the condensation drain holes are always located at the lowest part of the
Note
Observe the technical data on the rating plates attached to the motor enclosure.
5.1.2

Safety instructions: Explosion-proof machines

Note
The increased level of danger in hazardous areas demands that you pay particular attention
to the notes marked with
Low-voltage motors
Operating Instructions, 05/2014, 5 610 00000 02 000
WARNING
has been set by the customer, e.g. by decoupling from the driven load.
machine enclosure.
motor.
.
5
31