Xerox VersaLink Series System Administrator Manual page 46

Network Connectivity
5. When prompted with an acknowledgement message about the printer restarting, touch Continue.
Note: The printer restarts later in the procedure.
6. One at a time, touch the fields for IPv4 Address, IP Gateway Address, and Network Mask Address,
then type the IP addresses into the fields. After each address, touch Enter.
7. Touch Restart.
The printer restarts.
C C o o n n f f i i g g u u r r i i n n g g I I P P S S e e t t t t i i n n g g s s i i n n t t h h e e E E m m b b e e d d d d e e d d W W e e b b S S e e r r v v e e r r
If your printer has a valid network address, you can configure TCP/IP settings in the Embedded Web
Server. For details, refer to
S S e e l l e e c c t t i i n n g g B B e e t t w w e e e e n n I I P P v v 4 4 a a n n d d I I P P v v 6 6 P P r r o o t t o o c c o o l l s s
You can configure the printer to communicate with networks that use IPv4, IPv6, or both.
1. In the Embedded Web Server, log in as administrator, then click Connectivity.
2. In the Connections area, click Ethernet.
3. In the Common area, click Edit.
4. For Host Name, type the name to appear for the printer.
5. Click IP Mode, then select an option.
Note: The Dual Stack setting allows the router to assign IPv4 and IPv6 IP addresses, as needed.
1. When in Dual Stack mode, you can give priority to the IPv6 address for resources. For IPv6 Priority
over IPv4 at Domain Name Resolution, enable the toggle button.
2. Click OK.
C C o o n n f f i i g g u u r r i i n n g g I I P P v v 4 4 S S e e t t t t i i n n g g s s
1. In the Embedded Web Server, log in as administrator, then click Connectivity.
2. In the Connections area, click Ethernet.
3. In the IPv4 area, click Edit.
46 Xerox ® VersaLink
System Administrator Guide
Assigning a Network
® Series Multifunction and Single Function Printers
Address.