Xerox VersaLink Series System Administrator Manual page 177

V V e e r r i i f f y y i i n n g g t t h h e e I I m m a a g g e e P P o o s s i i t t i i o o n n
1. At the printer control panel, press the Home button.
2. Log in as administrator.
3. Touch Device→Support→Image Position.
4. Select the source paper tray for the registration print.
• Touch Paper Supply.
• Touch the desired tray.
5. If your printer has automatic 2-Sided printing, select the sides that you want to optimize.
• To select a sample registration page for adjusting Side 1, touch Adjusted Side, then touch
Side 1.
• To select a sample registration page for adjusting both sides, touch Adjusted Side, then touch
Side 2.
6. Specify the consecutive number of sample pages to print.
• Touch Print Settings.
• To increase or decrease the number of sample pages, for Quantity, touch the Plus icon (+) or
the Minus icon (-), then touch OK.
7. To print the sample pages, touch Print Sample.
8. When printing is completed, touch Close.
9. On the sample pages, for Side 1, use a ruler to measure the distance of the printed image from
the top, bottom, left, and right edges.
Note: For identification, a single dot is printed on Side 1, and two dots are printed on
Side 2.
10. For Side 2, measure the distance of the printed image from the top, bottom, left, and right edges.
11. If the image is centered, no adjustment is required. If not centered, adjust the paper registration.
For details, refer to
P P e e r r f f o o r r m m i i n n g g a a n n I I m m a a g g e e P P o o s s i i t t i i o o n n A A d d j j u u s s t t m m e e n n t t
1. At the printer control panel, press the Home button.
2. Log in as administrator.
Performing an Image Position
Xerox ® VersaLink ®
Adjustment.
Series Multifunction and Single Function Printers
System Administrator Guide
Administrator Tools
177