ProForm 831.15934 Owner's Manual page 8

14. Attach the Seat (28) to the Upright (9} with the two
1/4" x 3/4" Bolts (20) and a 1/4" x 2 1/2" Bolt
(46).
15. Center one Pad Tube (22) in the Upright (9), and the
other Pad Tube in the Leg Developer (23). Slide the
four Small Pods (17) onto the ends of the Pad Tubes.
16. Rest the Left and Right Pedals (75, 76) on the hooks
at the lower ends of the Resistance Cylinders (84).
Make sure that the hooks are fully inserted into the
same slots under both Pedals.
Plug the TransFormer (39) into the jack located near
the bottom of the Right Side Shield (12).
17. Make sure that oil ports are properly tightened. The use of oil remaining PoX will be explained in ADJUSTING
THE CROSS TRAINER e, beginning on page 8 oFthis owner's manual.
18. Before using the CROSS TRAINER e, test the cables and the pulleys. Make sure that the cables are in the grooves
in the pulleys. If the cables do not move smoothly over the pulleys, locate and correct the problem before using
the CROSS TRAINER e. If the'€':ables are not properly routed, they will be damaged when used.
7