CyberData SIP PAGING ADAPTER Configuration Manual page 45

If you are configuring the Nightringer extension through the web interface, use the following
steps to register Nightringer with RingCentral.
1. Review Configure the SIP
2. From the Home page of the web interface, click SIP from the Top toolbar of the
screen.
2. Enter the provisioning information from the
Phone/Adaptor Provisioning
Note: the Local SIP Port is set to 5061 on default and is used by the SPA as its source
port for the Nightringer extension configured on this page.
4. Set the Re-registration Interval (in seconds) to 30 seconds.
5. Set the Keep Alive Period to 0.
6. Enable Force Codec Selection and use PCMU.
7. Click Save and Reboot to store changes.
RING CENTRAL CONFIGURATION GUIDE: SIP PAGING ADAPTER (SPA)
Parameters.
Nightringer's Assisted Generic IP
popup.
CyberData Corporation
3 Justin Court, Monterey, CA 93940
www.cyberdata.net
P 831.373.2601 | F 831.373.4193
Doc. 931050B Page 44