ORTAL offers interior media options such as stones, glass, logs and embers that can provided with the
fireplace unit. This section provides guidelines for safe placement of media.
WARNINGS – INSTALLING AND HANDLING MEDIA
•
DO NOT install the interior design media until appliance installation is complete, the gas line
is connected and tested for leaks, and initial burner operation has been inspected and
approved.
•
Media materials get very hot and will remain hot up to one hour after gas supply is turned
off. Handle media only when materials are cool.
•
If media is not installed according to the installation instructions, flame impingement and
improper combustion may occur and result in soot and/or excessive production of carbon
monoxide (CO). Carbon monoxide is a toxic, colorless, and odorless gas.
WARNING – The appliance is NOT designed to burn wood. Any attempt to do so could cause
irreparable damage to the appliance and may result in property damage, personal injury and/or loss of
life.
Media Placement Guidelines
When installing media, adhere to the following general guidelines:
•
Keep the media back from the pilot hood so at least one burner port is open. Otherwise, there
will be delayed ignition.
•
Do not use the hood to support media. This could cause overheating of the thermocouple.
•
Keep the media away from the edges and the glass.
•
Do not overfill the media tray. Keep 30% of the tray open to allow for air flow.
Glass Media Placement
•
When placing glass media, put only a single layer, and do not pack down. Once the media is
placed, go back and move the glass back slightly to open the ports:
Ortal Installation Manual: Built-in Models, September 2018
Interior Design Media
77