Using The Built-In Mounting Slots - Aruba AP60 Installation Manuals

Aruba AP60/61: Installation Guide

Using the Built-In Mounting Slots

The keyhole-shaped slots on the back of the Aruba AP60/61 can be used to
attach the device upright to an indoor wall or shelf.
C
AUTION
sideways, or in any place where it could fall on people or equipment. For more secure
installation, use one of the optional mounting kits.
To hang the Aruba AP60/61 upright using the mounting slots, perform the
following steps.
1 Install two screws in the wall or shelf as shown in
Screw/Nail Positions
(fastened to wall or shelf)
12.7 cm
If attaching the device to drywall, we recommend using appropriate wall
anchors (not included) as shown in
28 Part 0500034-05
—Do not use the mounting slots to hang the Aruba AP60/61 from the ceiling,
(5.00")
F 3-3 Mounting Screw Specifications
IGURE
Screw/Nail Dimensions
Maximum Minimum
7.0 mm
5.8 mm
2.0 mm
3.8 mm
clearance
from surface
3.0 mm
0.27"
0.23"
0.08"
0.15"
clearance
from surface
0.12"
Figure 3-4 on page 29.
Figure 3-3:
1.3 mm
clearnace
from surface
0.05"
clearance
from surface
May 2005