Aruba AP60 Installation Manuals page 27

Specific Locations
By setting specific location IDs for each AP , you can later apply configu-
ration changes or collect statistics and information for specific groups
of APs (for example, all APs on a particular floor in a particular build-
ing).
To set a specific location for an individual AP , the following command is
used:
setenv location <building number>.<floor number>.<device number>
where the following fields are required:
A unique number (1-254) is required for each building in
Building Number
your campus.
Floor Number Within any building, a unique number (1-254) is
required for each floor.
Device Number Within any floor, a unique number (1-65534) is required
for each access point or air monitor.
If you performed the recommended site survey using the Aruba RF Plan
tool, the location data for all access points and air monitors can be
found on the tool's deployment page (see the Aruba RF Plan User's
Guide).
If you prefer to enter the location data manually, record the location ID
you set for each access point and air monitor along with the following:
Device Note the intended function of the device (access point
Description or dedicated air monitor) and a brief description of its
service location.
Chapter 2
Provisioning Access Points 21