Aruba AP60 Installation Manuals page 23

3 Connect the adapter's "To Network" RJ-45 connector to the
LAN.
The LAN connection is optional unless POE is being used to power the AP . For
convenience, the adapter kit includes an FE coupler to connect RJ-45 cable
ends together.
4 Connect power to the Aruba AP60/61.
—Be sure to comply with electrical grounding standards during all phases of
C
AUTION
installation and operation of the AP. Do not allow the Aruba AP60/61 or optional power
adapter (if used) to be connected to or make contact with metal or power outlets on a
different electrical ground than the device to which it is connected. Also, never connect the
AP to external storm grounding sources.
The Aruba AP60/61 can receive electrical power using the following options:
POE–If connecting the Aruba AP60/61 to a device that supplies IEEE
802.3af compliant POE, no additional power connection is necessary.
Power Outlet
N —When the Aruba AP60/61 is installed in an air-handling space, as described
OTE
in NEC (2002) Article 300.22(C), POE must be used instead of a power outlet.
If local regulations and practices permit, connect the optional AC power
adapter (not included) to the DC power socket on the rear panel of the Aruba
AP60/61 and plug it into an appropriate power outlet.
C
AUTION
adapter certified for this device in the country where it is used.
—The indicator LEDs on the Aruba AP60/61 will remain dark during this procedure.
N
OTE
5 Set your local terminal to use the following communications:
T
ABLE
Baud Rate Data Bits
9600
6 Establish console communication.
Press <Enter> a few times to establish communication between the Aruba
AP60/61 and terminal.
7 From the Aruba AP60/61 console, access the apboot prompt.
Depending on the Aruba AP60/61 status, you will see one of the following on
your terminal:
—To prevent personal injury or damage to equipment, use only the AC power
2-1 Console Terminal Settings
Parity
8 None
Stop Bits Flow Control
1 None
Provisioning Access Points
Chapter 2
17