How To Set Up Parameters - Omron V700-D23P41 User Manual

5.2 How to set up parameters

Various parameters are set up using a terminal software loaded into an upstream controller (PC/AT)
connected to the SECS port of CIDWR controller. The communications parameters for data transaction
between the upstream controller and CIDRW controller are fixed and cannot be altered on the CIDWR
controller side. On the terminal software side, set up the communications parameters, transmission code,
indications, etc., as listed below:
Baud rate
Date length
Parity
Stop bit
Communication control
Transmission code
Indication
Once entering setup mode, the basic screen below will appear on the terminal display of the upstream
controller.
SETUP_START <L21 ><XXX.XX,YYY.YY>
*<"Modelnumber"><"SoftwareRevisionLevel", "HardwareRevisionLevel">
The setting-capable parameters are as listed below:
Parameter list
Category
Protocol Baud rate (BAUD)
Protocol Device ID (DEVID)
Protocol Inter-character timeout (T1)
Protocol Protocol timeout (T2)
Protocol Reply timeout (T3)
Protocol Inter-block timeout (T4)
Protocol Retry limit (RTY)
Protocol Master/slave (M/S)
SECS Dual block detection
SECS Source ID
SECS Single block No.
Service Baud rate to link unit
Service Number of heads count
9600 bps
8 bit
EVEN
1
None
Add a line feed character (LF) to the end of line (ENTER is input).
Local echo
Parameter Tag name
S_BAUD
S_DEVID
S_T1
S_T2
S_T3
S_T4
S_RTY
S_MS
S_DB
S_SRC
S_BNO
C_BAUD
C_HEAD
Default
9600 1200,2400,4800,9600,19200,
38400,57600,115200
0 0 - 32767
0.5s 0.1 - 10s
10s 0.2 - 25s
45s 1 - 120s
45s 1 - 120s
3 0 - 31
M: Master M: Master
S: Slave
1: Perform 1: Perform
2: Not perform
0 0 - 32767
1 0,1
9600 9600,19200,38400
0 0 - 31
0 : Auto count
1 - 31 : Number of heads specified
Section 5
Setup Mode
Range
V700-L21
63
User's Manual