Cleaning The Ts500 Drive Rollers Using A Cleaning Card - Digital Check TellerScan TS500 User Manual

TellerScan TS500 User Manual
®
Rev 111618

Cleaning the TS500 Drive Rollers Using a Cleaning Card

Use the Digital Check scanner cleaning cards (PN: IS0033 - available at www.digitalcheck.com) for routine
cleaning maintenance.
Note: In order to maintain optimum performance, it is recommended to use a cleaning card after every 10,000
item scans. This process takes less than 2 minutes to complete. It is advised to work out a schedule that allows
regular cleanings to be performed.
Step 1: Press the Smart Button 3 times in a span of 3 seconds to start the scanner's cleaning mode.
Step 2: Slide the cleaning card forward until it reaches the line indicated on the scanner cover. The scanner
will begin the automated cleaning process.
Correctly inserted
Step 3: The scanner will automatically scrub the feed rollers against the cleaning card and then feed the card
through the scanner. Once fed through, remove the cleaning card from the exit pocket and place it back in the
entry pocket. The scanner will repeat this step 2 more times. This is one complete cycle and the scanner will
run through 3 complete cycles before finishing.
Step 4: Press the Smart Button 1 time to exit the cleaning mode and wait 60 seconds for the cleaning for the
cleaning fluid to dry from the scanner and for the Clean LED to turn off.
Page | 18