Tellerscan Ts500 Initial Setup; New User Notice; Cable Connections And Scanner Placement - Digital Check TellerScan TS500 User Manual

TellerScan TS500 Initial Setup

New User Notice

PLEASE NOTE: Digital Check does not provide scanning software. Do not connect the USB cable from the
scanner to your PC prior to installing the drivers or the scanning application / software. Please contact your
bank or other solution provider for further assistance with installing the driver or getting the scanning software
set up or installed.
Digital Check only provides an optional driver installation utility and testing software. See the Installing the
Optional USB Driver section or the Installing the TS500 Test Software section for additional information.

Cable Connections and Scanner Placement

Note: Do not connect the USB cable from the scanner to your PC before installing the drivers or the
scanning application / software.
✓ When handling the TS500, grip it with two hands on the front and back of the scanner.
✓ Place the unit on a flat surface near the PC away from direct light sources such as spotlights or desk
lamps. Place the scanner in a position that is at least 6 inches away from any power supply, other
electronic devices, pneumatic tubes at the teller window, etc. to avoid magnetic interference with the
MICR read head.
✓ Connect the power cord to the power supply, and then plug the connector into the rear power
connection port on the scanner.
✓ Connect the USB cable by plugging it into the rear USB connection port.
TellerScan TS500 User Manual
®
Rev 111618
Page | 8