Rotating And Replacing The Discriminator Pad - Digital Check TellerScan TS500 User Manual

TellerScan TS500 User Manual
®
Rev 111618

Rotating and Replacing the Discriminator Pad

Note: The discriminator pad is user-replaceable. If the pad is worn on one surface, it can be rotated to an
unworn side. If all sides of the pad are worn, it can be replaced. This is typically only needed for scanners that
have been in service for longer periods of time, or for teller windows and higher-volume remote deposit
settings. (PN: 155177-01 - available at www.digitalcheck.com)
Step 1: Open the center cover and the feed roller door to provide access to the discriminator pad. See the
Accessing the TellerScan TS500 section for additional information.
Step 2: Lift or pull up on the discriminator pad to remove. There are no tools required for removal.
Discriminator Pad
Step 3: Rotate the pad to an unworn side. If all sides of the pad are worn replace with a new discriminator pad.
Reinsert the pad into the scanner, push down completely, and close the center cover and feed roller door.
Worn side of pad Rotate pad 90°
Page | 19