Install The Windows And Door - Real Good Toys Victoria’s Farmhouse Instructions Manual

Instructions for Special Edition Kit #JM-1065 Victoria's Farmhouse
c 10. Paint the Shutter parts. Without glue, adjust the spacing
of the Shutter Panels on the Shutter Cores. Remove the Shutter
Panel, put a scant line of glue on each edge of the back surface,
then replace the Shutter Panel. Too much glue will make the
panel curl.
VI. Install the windows and door
The parts used in this section should be painted ahead of time.
If they have not been painted, do so now.
1. Touch-up the sanding and paint. Check the fit of the door
c
in the opening. Make sure the door can sit level with the house.
Trim the corners of the opening square if necessary for a good fit.
c 2. Glue the door in place only after the housebody is painted.
3. Install the Windows and Doors.
c
c 4. Glue the Shutters in place against the Windows, centered
up and down (Illustration #1).
Do not install Interior Trim until interior finishing is done.
Shutter is Centered
Up-and-Down
Illustration #1
Centered
Windows (5) page 16
Shutter Panel
Shutter Core
Shutter
Core
Shutter Panel