Glue And Tape The Middle Floor To The Walls - Real Good Toys Victoria’s Farmhouse Instructions Manual

Instructions for Special Edition Kit #JM-1065 Victoria's Farmhouse
c 5.
Test the Middle Floor in the grooves in the
Gable Front and Gable Left Side. Sand the top and bot-
tom at the edges if necessary for a good fit.
Glue and tape the Middle Floor to the Walls, fully into
the grooves of the Gable Front/Left Side, with the walls
lined up with the ceiling tracing and flush at the back
edge (Illustration #9).
c 6.
Glue and tape the Second Floor walls in place
following the tracing. Make sure the right side walls line
up at the back edge, and look lined up with each other
when viewed from the front.
c
7. Glue and tape the Top Floor/Gable Floor to the
walls, lined up with all of the walls on the outside (Illus.
11). If you are going to wire your dollhouse, trace and
carve the bottom of the Electrification slot to make it
exposed inside the Left Side Wall (don't make it deeper
at the top, just at the bottom) before gluing on the floor
Carve for tapewire access to Electrification slot
Top Floor
c 8.
Glue and tape the Access Bay Spacer to the
Gable Left Side and to the Top Floor (Illus #11).
Note: The AccessBay Spacer is smooth - it is hidden by
other parts.
c
9. Glue and tape the AccessBay Mid Floor and Ac-
cessBay Base Floor the the Middle Floor and Base Floor
(Illus. 11, see also step 1, page 10)
c
10. Glue and tape the Housebody's Left Side to
the Floors and Spacer, tight in the grooves and lined up
.
at the back edge
Top Floor
Illus. 11
Attic Endwall
will go here
Left Side Wall
Lined up
Lined up
AccessBay Mid Floor
AccessBay Base Floor
Left Side
Note: clean paint out of the grooves!
Gable Front:
fits in the groove
Illustration #9
Glue and Tape the
Middle Floor to the
Walls - Tight in the
Groove.
Lines up in back
Use a Divider here to straighten
and line up the Right Side
Lines up in back
AccessBay Spacer
( 3 / mdf) 1 1 / x 6 1 /
8 2 4
Review:
• Look at the housebody from every angle.
Everything should be tight and lined up.
( 3 / mdf) 1 x 6 1 /
8 4
• Make sure the housebody is on a flat
surface as the glue dries.
• Prop dividers between the floors to keep
them straight.
( 1 / mdf) 1 x 6 1 /
4 4
• Add weight and plenty of tape to keep
everything tight and straight as the glue
dries.
Housebody (1) page 10
Use a Divider here to support
and line up the corner
Illus. 10