Glue/Tape Access Bay Sides To Housebody’s Walls/Access Bay Floors; Hinge The Access Bay Front In Place - Real Good Toys Victoria’s Farmhouse Instructions Manual

Instructions for Special Edition Kit #JM-1065 Victoria's Farmhouse
c 6. Set an Access Bay Side on the edge of your work-
bench with the clapboard up. Let the Access Bay Front
Hang off the front of the workbench. Fold the Hinges across
the clapboard surface of the Access Bay Side. Line up the
top edges of the Access Bay Front and Access Bay Side
(check the clapboard profile again) see Illustration #4.
Builder's tip: let the Accessbay Front hang a little bit away
from the Accessbay Side so they won't be quite touching in
the assembled house.
7. Tape the Hinges to the Side. Punch a starter hole
c
and drive the screws as you did for the Front, then take the
screws back out of the Front (it's easier building the house
without the Access Bay Front attached).
c 8. Glue and tape the Access Bay Sides to the house-
body's walls and Access Bay Floors (Illustration #5).
c 9. Glue and tape the Access Bay Ceiling to the house
and tops of the Access Bay Sides, lined up on the outside.
c 10. Glue and tape the Access Bay Roof to the Access-
Bay Ceiling, centered side-to-side (Illus. 6).
c 11. Hinge the Access Bay Front in place using the holes
prepared in step #5.(Illustration #6).
Illustration #5
Glue and Tape the Access Bay
Sides to the Housebody's Walls &
Access Bay Floors
AccessBay Side
Left Side
AccessBay Front
Illustration #6
Hinge the Access
Bay Front in Place
Illustration #4
Access Bay Left Side
Access Bay Front
Screw
Hinge
Masking Tape gives
clearance here
AccessBay Front
AccessBay (4) page 14
Workbench
Lined Up
AccessBay Side
AccessBay Roof
AccessBay Ceiling