Window Assembly - Real Good Toys Victoria’s Farmhouse Instructions Manual

Instructions for Special Edition Kit #JM-1065 Victoria's Farmhouse
V. Window Assembly:
The parts used in this section should be
painted ahead of time. If they have not
been painted, do so now.
www.realgoodtoys.help has more
window assembly photos
1. Standard Windows: Test assem-
ble (no glue) the window set.
Practice holding the frame pieces face-
down on the work surface and putting on the
rubber band. When you can do it every time
without pieces flying, then you are ready for
glue (Illustration #1).
2. Glue and rubber band together the
window frame with the Window Plexi in
place. Make sure the assembly is square as
the glue dries (Illustration #2).
3. Short and the Narrow Windows:
assemble these windows as you did the
Standard Window.
4. Standard Double Window:
Lay out and assemble the Double Win-
dow face down on the work surface
(Illustration #4).
5. Turn the Double Window face up
and push the Middle Frame down to the
work surface. Adjust the spacing of the
Middle Frame with the 1
lustration #5).
6. Glue the Trim to the Frames cen-
tered on the Middle Frame.
7. Narrow Double Window: As-
semble the Narrow Double Window as you
did the Standard Double Window using the
1 / " Spacers to locate the Middle Frame.
3
16
8. Touch-up the sanding and paint, but
stay away from the Window Pane!
9. Check the fit of the windows in
the openings. Make sure the windows
can sit level with the house. Trim the
corners of the openings square if neces-
sary for a good fit.
Window Plexi
Face Down
/ " Spacers (Il-
15
16
Illustration #1
These hands are holding the frame parts down
against the table (not squeezing them together)
A snip of tape in the corners helps
keep the parts still while you put put
on the rubber band, but take off the
tape while the glue dries.
Inside
Side Frame
Illustration #3
Trim
Illustration #4
1 15 / Spacers
16
Face Down:
Inside Showing
Side Frame
Bottom Frame
Middle Frame
Windows (5) page 15
Illustration #2
Top Frame
Plexi