Advertisement
Instructions for kit #71K
On the outside of all roof panels draw guidelines for locating
Shingles. The first guideline on each panel to be shingled should be
drawn one Shingle length (usually 1
the rest of the guidelines spaced 1" apart.
Note: The Shingle Boards on the roof's corners will separate the shin-
gling on the Front and Side Roofs, which are at different angles. That
difference makes the guidelines not line up with each other. If you are
not using the Shingle Boards, Transfer the guidelines from the Front
.
Roof to the Side Roofs
1. Set the Attic Divider close to the Tower side, lined up at the back
of the Third Floor.
2. Glue and tape the Right Front Roof and Right Side Roof panels
together. The Front Roof overlaps the Side Roof. Do not allow to dry.
Immediately glue and tape this assembly in place to the Tower Side and
the Third Floor. Move the Attic Divider and clean up glue squeezings,
then put it back not-quite touching the Tower Side. Make sure the Front
Roof is touching the Attic Divider all the way up-and-down. Tape.
3. Make the Side Roof parallel to the edge of the 3rd floor and
lined up at the back of the 3rd floor. Tape it there.
When the glue is dry, repeat steps 1- 3 for the Left Roof set.
Attic Divider
Lined up in back
Parallel
Tape
Roof Assembly
1
/
") from the bottom edge. Draw
4
Tape
Lined up
in back
A. Identify the outside
This is the outside of
the Roof Panels
B. Draw guidelines on the Front Roofs
Tape
Tight
Tape and weight to make everything tight
C. Transfer the guidelines to
the Side Roofs at the corners
D. Connect the transfer marks
for the Side Roof guidelines
Let the glue dry
Roofs (3) page 9
1"
Bevels
1"
1"
1"
1"
1"
1"
1"
One
Shingle
Length
Guideline
Measure
Advertisement
