Functions Of Various Parts - SATO MB200/201i Operator's Manual

Setup

Functions of various parts

RS-232C Allows connection to a computer
Interface or handy terminal
RS-232C Protects the RS-232C connector
cover from dust and damage
Cover Opens up to allow the installa-
tion of labels
Cover Enables the user to releases the
Open/ cover, or to lock the cover shut
Close
lever
Easy cut- Cuts printed labels
ter
IrDA filter Contains the IrDA (infrared)
sensor and emitter
DIP switch Sets the operation mode of the
printer. (See page 4-1.)
Dispenser Moved to select
unit Dispense mode
POWER Allows the user to turns ON/OFF
key the printer
Cover for special
Battery battery pack
cover
Battery Indicates the amount of battery
indicator power remaining for the printer
(LED)
2-4
Label Set to meet the size
guide of the label used
Label Allows adjustment of the label
guide guide to fit the width of an
adjust dial installed label roll
Cover for Protects the label guide adjust-
Label ment dial from dust or damage
guide
adjust dial
Label out- This is the area where the
put area printed label is output
Label width Indicates the width of label
markings installed or in use.
DC input Connects to AC adapter which
jack supplies direct current to the
printer
Cover for Protects the DC input terminal
DC input and DIP switch fro dust and
jack damage
FEED key Press to feed label
PRINT key Takes the printer Online
or Offline
Status LED Indicates the
status of the printer. (See pages
3-13,3-14, 6-1 and 6-2)
Belt clip Suspends the printer on a belt,
to allow greater mobility
* Do not hang the printer on to
anything but a belt