Table of Contents
Advertisement
Offset Configuration via Programming
The following offset adjustments for the MB200/201i
printer are usually unnecessary. Almost all
adjustments are electrical in nature due to the
printer's advanced self aligning and balancing design
features. However, if you need to perform the
adjustments, they can be sent as commands to the
printer. Consult your SATO representative for
information on programming the MB200/201i printer,
or refer to the Programming Reference guide found
on the CD-ROM.
Adjustment
Printer Setting
Commands
Base Point Offset
Pitch Offset
Dispense Offset
Tear-Off Offset
Base Point Offset
Operation and Configuration
POSITION ADJUSTMENTS
Method
Use
the
<PG>
programming
command.
Use
the
<A3>
programming
command.
Description
Saves the values
to the Flash ROM.
Takes effect
instantly; the
value is cleared
once the power is
turned off.
3-17
Advertisement
Table of Contents
