Recalling Stored Data; Erasing Data; Erasing Single Data Points - Hach sensION3 Instruction Manual

SECTION 4,
continued

4.2 Recalling Stored Data

4.3 Erasing Data

4.3.1 Erasing Single Data Points

1. To recall stored data, press the
Reading mode. The screen will display the most recently
saved or recalled measurement data.
2. Use the arrow keys to scroll to the desired storage location.
Press again to allow number entry of a storage
RECALL
location. The question mark will flash. Enter the number of
the desired storage location. Press
storage location or
3. When recalling is complete, press
Reading mode.
1. To erase data, it must be recalled first. Press the
while in the Reading mode. See Section 4.2 for
more information.
2. When the desired data point is displayed, press
3. The meter will display
to erase the data. The data will disappear.
ENTER
4. The meter will recall the most recently stored or recalled
sample data. There are three options at this point:
•
Press then
ERASE,
•
Press to exit Recall mode.
EXIT
•
Press an arrow key to scroll to other data points.
5. Repeat steps 2–3 for each data point that needs to be deleted.
34
RECALL
ENTER
to escape.
EXIT
EXIT
and a flashing
Erase Sample #
to erase the displayed data.
ENTER,
key while in the
to accept the
to return to the
key
RECALL
.
ERASE
. Press
?