Table of Contents
Advertisement
Section 4
4.1 The Datalog
4.1.1 Storing Data to the Datalog
4.1.2 Recalling, Sending, and Erasing Data from the Datalog
5940018Data.fm
Working with Data
This section describes how to work with data from the following reading modes:
Hach Programs, Single-wavelength, and User Programs.
The DR/2400 datalog will store up to 1000 data points. A complete record of the
analysis is stored, including the date, time, results, sample ID, and operator ID.
To store data, touch the
from within any Options Menu.
To recall data from the Datalog:
1. Touch the
2. If necessary, touch
3. Touching any data point on the Datalog screen causes it to be
highlighted.
Note: Alternatively, touch Options from one of the modes listed in Section 4.1, and
then Recall Data.
Details
Touch
View Details
information about the highlighted data point.
Filters
To select data by
•
sample ID,
•
operator ID,
•
parameter,
•
date,
or any combination of the four, touch
Touch
to turn on the filters. Touch the checkbox next to each filter to be
On
applied. Change the criteria for each type of filter by selecting it and entering the
desired settings. Touch
To see all the data again, return to this screen and turn filters
icon on any reading screen, or
Store Data
icon.
Recall Data
.
Datalog
on the Recall Data screen to view all the
Filters
. Only the data that match the criteria will appear.
OK
on the Recall Data screen.
.
Off
Working with Data
Page 37
Advertisement
Table of Contents
