Recalling Stored Data - Hach sension6 Instruction Manual

SECTION 4,
continued

4.2 Recalling Stored Data

arrow keys to scroll to that location number or enter a
location using the number keys. Press
3. If all memory locations are full, the meter will prompt to
overwrite one of the data points by displaying
Press
##?
ENTER
current data. Press
without replacing the data.
4. The meter will store the reading and return to Reading mode.
1. To recall stored data, press the
Reading mode. The screen will display the most recently
saved measurement data.
2. Use the arrow keys to scroll to the desired storage location, or
press again to allow number entry of a storage
RECALL
location. The question mark will flash. Enter the number of
the desired storage location. Press
storage location or
3. Press the
CONC %
concentration in mg/L and % saturation.
4. Press the
ENTER
5. Press the
ENTER
6. Press the
ENTER
7. Press the key twice to view the time and date of the
TIME
stored value.
8. When recalling is complete, press
Reading mode.
50
to replace the data in that location with the
to return to the previous screen
EXIT
RECALL
ENTER
to escape.
EXIT
key to switch between the stored
key to view the salinity.
key to view barometric pressure.
key to view the altitude.
EXIT
.
ENTER
Erase Sample
key while in the
to accept the
to return to the