Cases That Require Changes - NEC Express5800 Series User Manual

Chapter 3 Setup
2.4

Cases that Require Changes

Only if a case applies to any of following cases, use SETUP to change a parameter which was configured as
factory setting. Other than cases described below, do not change the settings. A list of SETUP parameters
and factory settings are described in Chapter 2 (1. System BIOS) in "Maintenance Guide".
Category
Basic Change date and time
On/Off NumLock on power
ON
On/Off the function to
display NEC logo during
POST
Memory Add or change DIMM
Use memory RAS feature
Optional Start the system from
board installed option board.
Boot Set the boot mode to UEFI
mode according to your
OS.
Set the boot mode to
Legacy BIOS mode
according to your OS.
Change the boot order of
devices
Use remote power on
feature (via modem)
Use remote power on
feature (via RTC alarm)
Use console redirection
feature
Enable X2APIC feature
according to your OS.
Disable X2APIC feature
according to your OS.
Description
Main → System Date
Main → System Time
Boot → Bootup Numlock State → ON or
OFF
Boot → Quite Boot → Disabled
Advanced → Memory Configuration →
Memory Retest → Yes
Advanced → Memory Configuration →
Memory RAS Mode → change to RAS mode
Advanced → PCI Configuration → PCI
Device Controller and Option ROM
Settings → PCIXX Slot Option ROM →
Enabled
Boot → Boot Mode → UEFI
Select UEFI mode for the following OS.
– Windows Server 2012
– Windows Server 2012 R2
Boot → Boot Mode → Legacy
Select Legacy mode for the following OS.
– Windows Server 2008
– Windows Server 2008 R2
Boot → Boot Option Priorities → Change
the boot priority
Advanced → Advanced Chipset
Configuration → Wake On Ring → Enabled
Advanced → Advanced Chipset
Configuration → Wake On RTC Alarm →
Enabled
Advanced → Serial Port Configuration →
Console Redirection Settings → Change
respective setting.
Advanced → Processor Configuration →
X2APIC → Enabled
Enable X2APIC for the following OS.
– Windows Server 2012
– Windows Server 2012 R2
Advanced → Processor Configuration →
X2APIC → Disabled
Disable X2APIC for the following OS.
– Windows Server 2008
– Windows Server 2008R2
Express5800/R120g-1E User's Guide
To be changed
2. BIOS Setup Utility (SETUP)
Remark
Configurable on OS
By pressing <Esc> key, prevent
the display of the logo.
After rebooting, Memory Retest
changes No automatically.
Some of RAS features may not
be used depending on DIMM
configuration.
XX is PCI slot number of the
installed option board
See "Before Starting Setup" in
Chapter 1 (Installing Windows)
in Installation Guide to
determine the boot mode.
See "Before Starting Setup" in
Chapter 1 (Installing Windows)
in Installation Guide to
determine the boot mode.
When you use
EXPRESSBUILDER, set
CD/DVD to the highest priority.
In console redirection
connection, if the corrupted text
is displayed on terminal screen,
change font type (character
code) appropriate to your
environment.
See "Before Starting Setup" in
Chapter 1 (Installing Windows)
in Installation Guide to select
Enabled or Disabled.
See "Before Starting Setup" in
Chapter 1 (Installing Windows)
in Installation Guide to select
Enabled or Disabled.
121