C) Using Clerk Card; D) Using Clerk Ibutton; E) Using Clerk Bar Code; F) With A Fingerprint (V1.60) - Uniwell HX-4500 Operation Manual

c) Using clerk card

To use this option HX must have a card reader fitted and be specially programmed to recognize the cards
(Program > Clerk > Clerk > General, and Program > Clerk > Clerk > Clerk System Option).
To sign on a clerk using a card, swipe the card through the reader.

d) Using clerk iButton

For this system HX must have an iButton reader fitted and be programmed to recognize the clerk iButtons.
To sign on a clerk using an iButton, touch the iButton to the iButton reader.

e) Using clerk bar code

For this system HX must have a scanner connected and be programmed to recognize the clerk Barcode
(Program > Clerk > Clerk > General). Do not use the same bar code as PLU for Clerk bar code. If the
same bar code is programmed for both PLU and clerk, it will be regarded as Clerk bar code.
To sign on a clerk using a bar code, scan the bar code by scanner.

f) With a fingerprint (V1.60)

For this system HX must have a fingerprint reader connected and be programmed to recognize the
fingerprint of the clerk (Program > Clerk > Clerk > General).
To sign on a clerk with a fingerprint, put the finger on the fingerprint reader.

g) With RFID (V2.80)

For this system HX must have an RFID reader connected and be programmed to recognize clerk Card
Login (Program > Clerk > Clerk > General). Do not use the same RFID as a Customer card.

1-3. Signing off a clerk

A clerk is automatically signed off:
- When a clerk finalizes a transaction by Media/NB closing in the clerk interrupt system.
- When a clerk is interrupted by another clerk (only in the clerk interrupt system).
- By pressing CLERK (ID) key, which stores any transaction.
- If using a magnetic card, the clerk can be signed off by any of the above methods and also by swiping the card
again.
- When using a magnetic iButton, the clerk can sign off by removing the iButton.
- When using a non-magnetic iButton, the clerk can sign off by touching the iButton again.
- If using a clerk bar code, the clerk can sign off by scanning the bar code again.
From V2.50, a clerk will sign off if iButton is removed when the following dialog is open. At the
same time, the dialog will be closed. This is to release the "Clerk sign-on" condition and avoid "Clerk
busy" condition at Phoenix, etc.
- Customer Order
- Split Bill
2