Input Source Selection (Component, Rgb Scart 21-Pin) - Sanyo PLC-XE40 Owner's Manual

Video Input

Input Source Selection (Component, RGB Scart 21-pin)

Direct Operation
Select Computer 1 by pressing the COMPUTER button on
the remote control.
Before using COMPUTER button, select the correct input
source through Menu operation as described below.
Menu Operation
1 Press the MENU button to display the On-Screen
Menu. Press the Point
framed pointer to the Input Menu icon.
2
Press the Point
pointer to Computer 1 and then press the SELECT
button.
3 After the Source Select Menu appeared for Computer
1, move the pointer to Component or RGB(Scart) and
then press the SELECT button.
When the input source is coming from
Component
video equipment connected to the
COMPUTER IN 1 / COMPONENT IN
terminal with a Component-VGA Cable,
select Component.
When the input source is coming from
RGB (Scart)
video equipment connected to the
COMPUTER IN 1 / COMPONENT IN
terminal with a Scart-VGA Cable, select
RGB (Scart).
✔
Note:
• Computer 2 is not displayed when the COMPUTER IN
2/MONITOR OUT terminal is set as Monitor out. (p. 45)
• Computer 2 (COMPUTER IN 2 / MONITOR OUT) can accept only
RGB signal.
36
buttons to move the red
7 8
ed buttons to move the red arrow
Remote Control
COMPUTER button
COMPUTER button
Input Menu icon
Input Menu
Move the pointer (red
arrow) to Computer 1
and press the SELECT
button.
Computer
1
Source Select Menu
Move the pointer to
Component or RGB(Scart)
and press the SELECT
button.
Computer 1
Computer 2