Sanyo PLC-XE40 Owner's Manual page 45

Ceiling
When this function is "On," the picture is top/bottom and
left/right reversed. This function is used to project the
image from a ceiling mounting the projector.
Rear
When this function is "On," the picture is left/right
reversed. This function is used to project the image to a
rear projection screen.
Terminal
The COMPUTER IN 2/MONITOR OUT terminal on the back
of the projector is switchable for computer input or monitor
output. (p. 9) Select Computer 2 or Monitor Out with the
Point 7 8 buttons.
Computer 2 . . . .computer input
Monitor Out . . .monitor out
Terminal function is not available when selecting Computer
2 to the input source. Change the input source to the
others (Computer1 or Video) so that the Terminal function is
available. (pp. 26, 35, 36)
Power management
For reducing power consumption as well as maintaining the
lamp life, the Power management function turns off the
projection lamp when the input signal is interrupted and no
button is pressed for a certain period.
When the input signal is interrupted and no button is
pressed for 30 seconds or more, the timer display with "No
signal" appears. The countdown starts to turn off the lamp.
Select one of the operations.
Ready . . . . . . . When the lamp has been fully cooled
down, the POWER indicator changes to
green blinking. In this condition, the
projection lamp is turned on if the input
signal is reconnected or any button on the
remote control is pressed.
Shut down. . . When the lamp has been fully cooled
down, the power is turned off.
Off. . . . . . . . . . Power management function is off.
Then set the countdown timer with the Point 7 8
buttons.
Ceiling
Rear
Power management
Time left before Lamp is off.
Press the SELECT button
at Power management and
this box appears. Select
one of three settings with
the Point
go to the timer with the
Point ed buttons and set
time with the Point
buttons.
Setting
7 8 buttons, and
7 8
45