Sanyo PLC-XE40 Owner's Manual page 25

AUTO PC button
Press the AUTO PC button to operate the Auto PC function.
For more detail, see p. 28.
D.ZOOM buttons
Press the D.ZOOM buttons to zoom in and zoom out the
images.
For more detail, see p. 34.
NO SHOW button
Press the NO SHOW button to black out the image. To
restore to normal, press the NO SHOW button again or
press any other button. When a projected image is
captured and set as "User" in the Logo selection (p. 43),
the screen changes each time you press the NO SHOW
button as follows.
black out ➜ the captured image ➜ normal ➜
KEYSTONE button
For detail, see p. 23.
IMAGE button
Press the IMAGE button to select an image level of the
screen.
For more detail, see pp. 31, 38.
P-TIMER button
Press the P-TIMER button. The timer display "00 : 00"
appears on the screen and the timer starts to count time
(00 : 00 ~ 59 : 59).
To stop the P-Timer, press the P-TIMER button. Press the
P-TIMER button again, then the P-timer display disappears.
LAMP CONTROL button
Press the LAMP CONTROL button to select the lamp mode
for changing the brightness of the screen.
Normal ....Normal brightness
Auto ........Brightness according with the input signal
Eco ..........Lower brightness reduces the lamp power
consumption
lamp life.
• • • • •
and extends the
Remote Control
VOLUME
+/- buttons
(See p. 24)
AUTO PC
button
D.ZOOM
buttons
NO SHOW
button
✔
Note:
• See the previous page for the other buttons.
The message disappears after 4 seconds.
P-Timer display
Basic Operation
KEYSTONE button
(See p. 23)
ed
POINT
buttons
IMAGE button
P-TIMER button
LAMP CONTROL
button
25