Table of Contents
Advertisement
•
Fit the screw-head caps.
•
Ensure the rail end caps are properly fitted.
•
Screw the rail mount clamp to the rear of the power supply module with the screws
supplied
•
Slacken sufficiently the light clamp to allow the clamp to pass over the rail and fit the
light to the rail.
•
The light can be moved along the rail by slackening the clamp slightly and not
sufficiently to allow the light to become detached from the rail.
Desk Mounting
•
Screw the desk mount clamp to the rear of the power supply module with the screws
supplied
•
Slacken the clamp so that its jaws just clear the desk edge
•
Tighten the clamp sufficiently to provide a rigid mounting for the light
4. OPERATION
The light-head swivels on its mounting flexible
arm, and the arm itself also swivels where it fits
into its mounting, allowing the light patch to be
placed where you want it.
Press the push-button on the rear of the lamp to
turn the light on. Press and hold to adjust the
intensity. Press the push-button again to turn the
light off. Pressing the push-button again will turn
the light at the last set intensity.
If the light is disconnected from the mains and
reconnected the light's intensity is reset to its
brightest setting.
Note: Unplug the power supply if the light is not
going to be used for extended periods.
The light-head swivels on its mounting flexible
arm, and the arm itself also swivels where it is
mounted onto the power-supply module. This
rotation and the flexible arm itself allow the light
patch to be placed where you want it.
Push-button
6
controller
Advertisement
Table of Contents
