Charge Your Phone With The Multicharger; Charge Your Spare Battery With The Multicharger; Secure The Charger With A Cable Lock - Cisco 8821 User Manual

Accessories

Charge Your Phone with the Multicharger

When the phone is charging, the LED beside the phone lights red. When the battery is fully charged, the LED
turns off.
If your phone has a protective case, you don't need to remove the case before you charge the phone in the
multicharger. You adapt the multicharger to fit the phone.
The bottom of the phone has charging pins that need to be aligned with the connector in the bottom of the
multicharger cradle.
Procedure
Step 1
(Optional) Use a thin screwdriver to pry out the charging cup if your phone is in a protective case.
Step 2
Place your phone in the empty charging slot.
Make sure that the LED on the phone lights red. If the LED does not light up, remove the phone and reinsert
it into the multicharger.
Step 3
When you remove the phone from the multicharger, lift the phone forward and up to disconnect the connecter
from the magnets.
Step 4
(Optional) Slide the charging cup into the multicharger so that the cup is flush with the multicharger.

Charge Your Spare Battery with the Multicharger

You can charge a spare battery in the multicharger.
When the battery is charging, the Battery LED beside the battery lights red. When the battery is charged, the
Battery LED lights green.
Procedure
Place the battery in an empty spare battery slot, aligning the battery contacts with the charger connecter.
If the Battery LED does not light red, remove the battery and reinsert it into the battery slot.

Secure the Charger with a Cable Lock

You can secure your desktop charger with a laptop cable lock up to 20 mm wide.
Charge Your Phone with the Multicharger
Cisco Wireless IP Phone 8821 and 8821EX User Guide
75