Advertisement
Troubleshooting Tips
If you experience trouble running the sample code with the Z8FMC16100 Series Motor
Control Development kit, determine if any of the following items can resolve the issue
before contacting
Zilog Technical Support
•
Verify that you are using ZDS II version 5.0.0 or later.
•
Ensure that you are using the unmodified sample project code as described in
ing Sample Code in Debug Mode using ZDS II
•
Verify that you have properly connected the USB Opto-Isolator Smart Cable to the
host PC and the MC MDS board as described in
Driver Software and USB Smart Cable
properly aligned with DBG connector pin 1 of the MC MDS board.
•
After you have connected the 5 V DC power supply to the MC MDS board, the green
3.3 V DC LED D4 must be illuminated. If it is not illuminated, verify that power is
properly connected to the board as described in
Power Supply to the MC MDS Board
•
In ZDS II, navigate to
verify that the serial number for the USB Opto-Isolator Smart Cable interface is pres-
ent and selected. If the serial number is missing, reinstall the USB Opto-Isolator Smart
Cable driver software.
•
In ZDS II, verify that
•
In ZDS II, click the
errors.
•
Verify that the development board is not currently running any code
should not be spinning.
•
Try reloading the sample project as described in
Mode using ZDS II
If you perform these steps and cannot get the sample code to run, contact Zilog Technical
Support at www.zilog.com.
QS005406-0111
Z8FMC16100 Series Motor Control Development Kit
for assistance.
on page 7. Ensure that pin 1 of the cable is
on page 5.
←
Project
Settings
Z8FMC16100KITG - USB
button. Verify that the project rebuilds with no
Rebuild All
on page 6.
on page 6.
Step 3. Install the USB Smart Cable
Step 4. Connect the 5 V DC Universal
←
←
Debugger
Communication
is selected as the target.
Executing Sample Code in Debug
Quick Start Guide
Execut-
and
–
the motor
Page 14 of 15
Advertisement
