Troubleshooting and Developer
Guidelines
Overview
Before contacting Zilog Customer Support to submit a problem report,
follow the steps below. If there is a hardware failure, contact a local Zilog
representative for assistance.
Recheck Procedures with the Quick Start Guide
(QS0054)
Follow the procedures in the document Z8FMC16100 Series Motor Con-
trol Development Kit Quick Start Guide (QS0054) in the kit and verify
that the kit is setup as specified.
IrDA Port Not Working
If you plan on using the IrDA transceiver on the MC MDS module,
ensure that the hardware is setup as follows:
•
•
Zilog Customer Support Contact
For additional troubleshooting solutions, refer to ZDS II Online Help. For
valuable information about customer and technical support as well as
hardware and software development tools, visit the Zilog website
UM019204-0208
Z8FMC16100 Series Motor Control Development Kit
DIS_IRDA jumper J3 must be OUT (shunt not installed) to enable the
control gate that drives the IrDA device.
DIS_RS232 jumper J2 must be IN (shunt installed) to disable the
console serial port driver.
Troubleshooting and Developer Guidelines
User Manual
16