Advertisement
b. Select
Install from a list or specific location (Advanced)
If the Windows Logo testing dialog appears, select
Note:
c. Select
Search for the best driver in these locations
.
in search:
d. Browse to the following directory and click
<ZDS installation>\device drivers\USB\x32
e. Find the appropriate driver, and click
f.
Click
Finish
Windows 2000
Observe the following steps to install the USB Smart Cable for Windows 2000 systems.
a. Connect the Zilog USB device to the Host PC. The
should activate automatically after connecting the Zilog USB device for the first
time.
b. Click
in the
Next
c. Select
Search for a suitable driver for my device (Recommended)
.
Next
d. Select
Specify a location
e. Browse to the following directory and click
<ZDS installation>\device drivers\USB\x32
f.
Find the appropriate driver, and click
g. Click
Finish
Step 4. Connect the USB Smart Cable to the MC MDS Board
Observe the following steps to Connect the USB Smart Cable to the MC MDS Board.
1. Attach one end of the six-conductor ribbon cable (included) to the USB Smart Cable's
six-pin DBG connector. Pin 1 of the ribbon cable is indicated by a dark stripe (see Fig-
ure 3).
2. Attach the free end of the ribbon cable to the DBG connector on the MC MDS board.
QS005406-0111
Z8FMC16100 Series Motor Control Development Kit
to complete the installation.
Found New Hardware
and click
to complete the installation.
and
:
Next
.
Next
Found New Hardware
Wizard after it has been activated.
.
Next
:
OK
.
Next
Quick Start Guide
and click
.
Next
.
Continue Anyway
Include this location
Wizard
and click
Page 9 of 15
Advertisement
