ZiLOG Z8FMC16100 Series Quick Start Manual page 6

Z8 encore! mc product family. motor control development kit

Hide thumbs Also See for Z8FMC16100 Series:

Step 6. Apply Power to the Motor

The sample code causes Direction SWITCH S1 to change the direction of motor spin.

Run/Stop SWITCH S2 is set to turn the motor ON and OFF, and Speed Potentiometer R7

allows you to change the direction of motor spin and motor speed.

Observe the following steps to gradually apply power to the motor.

a. Slowly increase the adjustable power supply to 24 V DC. The 3-phase motor begins

to spin.

b. Experiment with the switches to see how simple it is to control the motor using the

Z8FMC16100 MCU installed on the kit's MC MDS board.

Step 7. Power Down the Motor and Development Kit

After seeing how the sample code operates, turn the adjustable power supply to 0 V DC

and unplug the 5 V DC universal power supply from the MC MDS board.

Executing Sample Code in Debug Mode using ZDS II

Observe the following steps to execute the sample code in debug mode using ZDS II.

1. Stop the preloaded sample code and turn power to the 3-phase motor and MC MDS

board off.

2. Install ZDS II – Z8FMC16100 Series Motor Control Series Software.

3. Install the USB Smart Cable driver software and USB Smart Cable.

4. Connect the USB Smart Cable to the MC MDS board.

5. Download and run the sample code in Debug mode using ZDS II.

Step 1. Stop the Preloaded Sample Code

If you have not already done so, apply the adjustable power supply to 0 V DC and unplug

the 5 V DC universal power supply from the MC MDS board.

Step 2. Install the ZDS II – Z8FMC16100 Series Motor Control

Series Software

Observe the following steps to install the ZDS II software tool.

a. Insert the ZDS II CD into your computer's CD-ROM drive. DemoShield launches

automatically. If DemoShield does not launch automatically, open the Windows

QS005406-0111

Z8FMC16100 Series Motor Control Development Kit

Quick Start Guide

Page 6 of 15

Table of Contents