Step 2. Set Switches And Jumpers - ZiLOG Z8FMC16100 Series Quick Start Manual

Step 1. Connect the 3-Phase Motor to the Kit
The 24 V DC 3-phase motor included with the kit features three spade connectors that plug
into spade lugs P1, P2 and P3 on the 3-Phase Motor Control Application Board. Connect
the motor leads to the spade lugs on the 3-Phase Motor Control Application Board as
shown in Figure 2.
Figure 1. MC MDS Board Mounted on 3-Phase Motor Control Application Board

Step 2. Set Switches and Jumpers

For initial setup, configure your jumpers and switches as indicated below.
• J2, DIS RS232 OUT (shunt not installed)
• J3, DIS IRDA IN (shunt installed)
• J4 2-3
• J5 2-3
• J6 2-3
• Switch S1 to the far left position
• Switch S2 to the RUN position
QS005406-0111
Z8FMC16100 Series Motor Control Development Kit
Quick Start Guide
MC MDS Board
DBG Connector
Pin 1
3-Phase Motor Control
Application Board
Page 3 of 15