Advertisement
Figure 3. Connecting the Six-Conductor Ribbon Cable to the USB Smart Cable
Step 5. Download and Run the Sample Code in Debug Mode
Observe the following steps to open the
AN0226-SC01.zip
file, downloadable from zilog.com) and run the sample code in Debug
mode using ZDS II.
a. Ensure that the switches and jumpers on the MC MDS board are set as described
in
Step 2. Set Switches and Jumpers
b. Connect and apply power to the development kit as described in
Standalone Mode
Do not apply power to the MC MDS board or application board unless
Caution:
the USB Smart Cable is connected both to the host PC and to the devel-
opment board's DBG port.
c. Run the ZDS II software. By default, the Zilog Developer Studio II program is
located in the
Programs
ZDS II_Z8Encore!_<version_number>
d. Select
Open Project
QS005406-0111
Z8FMC16100 Series Motor Control Development Kit
motordemo.zdsproj
on pages 2 through 6.
menu under
Start
:
ZiLOG ZDS II_Z8Encore!_<version_number>
from the
File
on page 3.
menu. The
Open Project
Quick Start Guide
sample project (see the
Running in
dialog box appears.
Page 10 of 15
Advertisement
