Editing A Stored Name And/Or Phone Number - Sanyo CLT-5812 Instruction Manual

UP016DH(CLT5812) ENG OM
DIRECTORY

Editing a stored name and/or phone number

1
Press the MEM key in the standby mode,
Select Memory
¨
2
Press the
key, or enter a number (0 - 9) to select
the memory location you would like to
edit, and press the MEM or
SELECT/CH key.
3
Press the MEM or SELECT/CH key again.
The following screen appears with the
memory location number that you have
selected in the display.
4
VOL/RING or
Press the
then press the MEM or SELECT/CH key. The following screen appears.
The cursor flashes, indicating that the display is ready for the name
to be edited. When a name has not been
stored, the cursor appears at the beginning
of the second line.
5
/TONE/
Use the
edit the name. (See page E23.) To edit only the phone number,
skip this step.
6
Press the MEM or SELECT/CH key. The
following screen appears.
The cursor flashes indicating that the display is ready for the
number to be edited.
7
Use the /TONE/
number key to edit the phone number. The phone number
cannot exceed 20 digits. (See page E22.)
If you don´t want to change the phone number, skip this step.
3/7/05 5:22 PM
¨ is displayed.
VOL/RING or VOL/RING
VOL/RING key to select ¨Edit MemoryXX¨,
, #/ , DELETE/TRANS, or any number key to
, #/ , REDIAL/PAUSE, DELETE/TRANS, or any
Page 27
E27