Editing A Stored Name And/Or Phone Number - Sanyo CLT-5810 Instruction Manual

UP015DH(CLT5810) ENG OM
DIRECTORY

Editing a stored name and/or phone number

1
Press the MEM key in standby mode,
Select Memory
¨
2
Press the
key, or enter a number (0 - 9) to select the
memory location you would like to edit,
and press the MEM or SELECT key.
3
Press the MEM or SELECT key a second time.
The following screen appears with the
memory location number that you have
selected in the display.
4
Press the
MemoryXX
¨, then press the MEM or SELECT key. The following
screen appears. The cursor flashes,
indicating that the display is ready for
the name to be edited. When a name
has not been stored, the cursor appears
at the beginning of the second line.
5
/TONE/
Use the
the name. (See page E21.) To edit only the phone number, skip
this step.
6
Press the MEM or SELECT key.
The following screen appears.
The cursor flashes indicating that the display is ready for the
number to be edited.
7
Use the /TONE/
number key to edit the phone number. The phone number
cannot exceed 20 digits. (See page E20.)
If you don´t want to change the phone number, skip this step.
3/9/05 10:37 AM
¨ is displayed.
VOL/RING or VOL/RING
VOL/RING or VOL/RING key to select ¨
, #/ , DELETE/CH, or any number key to edit
, #/ , REDIAL/PAUSE, DELETE/CH, or any
Page 25
Edit
E25