Storing Phone Numbers And Names - Sanyo CLT-5812 Instruction Manual

UP016DH(CLT5812) ENG OM
DIRECTORY

Storing phone numbers and names

Memory Dialing allows you to dial a number by pressing just a
few keys.
Your cordless phone stores up to 10 names/numbers in each handset.
Note:
In memory dialing operation, you must press a key within 30 seconds or the
phone will return to standby mode. If you return the handset to the base, the
phone will return to standby mode also.
1
Press the MEM key in standby mode.
Select Memory
¨
2
Press the
(0 - 9) to select the memory location where you would like to
store the number.
3
Press the MEM or SELECT/CH key.
4
Press the MEM or SELECT/CH key. ¨
Name
¨ appears and a cursor flashes
indicating that the display is ready for the
name to be entered.
If the Edit screen appears, the selected
memory location is already stored. Then
you must either edit the entry in this
location, delete the entry in this location,
Go Back
or select ¨
5
To enter a name (up to 13 characters), use the number keys.
• See the "Steps for entering names and special characters."
(See page E23).
• Use the #/
desired location.
• Use the DELETE/TRANS key to delete characters as needed.
• Press and hold the DELETE/TRANS key to delete all the characters.
• If a name is not required, go to step 6.
3/7/05 5:22 PM
¨ is displayed.
VOL/RING or VOL/RING key, or enter a number
Store
¨ to choose another location.
/TONE/
and keys to move the cursor to the
Page 21
E21