Sanyo CLT-5812 Instruction Manual page 10

UP016DH(CLT5812) ENG OM
GETTING
• After installing the battery packs in the handsets, charge your
handsets at least 15-20 hours before plugging into the phone line.
4
Place one handset in the base
unit and one handset in the
charging cradle for 15-20 hours
without interruption. The base or
charging cradle unit's LED light
(labeled CHARGE/IN USE or
CHARGE) illuminates once the
handset is placed in the base and
charging cradle. The LED light
will illuminate whether the
battery pack is connected or not.
If the base or charging cradle
CHARGE/IN USE or CHARGE LED
light does not illuminate:
• Check to see if each AC adapter
is plugged into each charging
cradle and the electrical wall outlet properly. (Use only the
supplied AC adapter. Do not use any other AC adapter.)
• Check to see if each handset is sitting correctly in each
charging cradle and making good contact with each
charging contacts.
5
Once the handset battery packs are fully
charged, connect the telephone line
cord to the TEL LINE jack and
to a telephone outlet.
Tip:
If your telephone outlet isn't modular, contact your
telephone company for assistance.
E8
3/7/05 5:21 PM Page 8
STARTED
Modular