Power Connection; Test Run - Grizzly G0750GV Owner's Manual

Power Connection

Electrocution
may occur if machine is
ungrounded,
connected to power, or
connected to an undersized
circuit. Use an electrician
or
personnel to ensure a safe
power connection.
Before the machine can be connected to the
power supply, there must be an electrical circuit
that meets the Circuit Requirements for 220V
on Page 13.
To minimize the risk of electrocution, fire, or equip-
ment damage, installation work and electrical wir-
ing MUST be done by an electrician or qualified
service personnel.
IMPORTANT: Using an incorrectly sized exten-
sion cord may decrease the life of electrical com-
ponents on your machine. Refer to Extension
Cords on Page 14 for more information.
To connect lathe to power:
1.
Press Emergency Stop button on front of
headstock.
2. Turn variable spindle speed dial fully counter-
clockwise so spindle will turn at lowest speed
at startup.
3. Plug cord into matching power supply recep-
tacle and power source as specified in Circuit
Requirements for 220V on Page 13.
To avoid unexpected start-up, keep the
Emergency Stop button pressed in until
instructed otherwise in the Test Run.
-24-
or fire
incorrectly
a qualified service

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The test run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the emergency stop button safety feature, work
lamp, and jog button all work correctly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
1. Clear away all tools and objects used during
assembly, lubrication, and preparation.
2. Secure chuck and jaws (refer to Chuck
Installation on Page 29).
Model G0750GV (Mfd. Since 03/18)