Lubrication - Grizzly G0750GV Owner's Manual

Lubrication

Use the information in the charts below as a daily
guide for lubrication tasks. We recommend using
Grizzly Model T23962 or T23963 lubricants (see
Page 55) for most of the lubrication tasks.
Lubrication Frequency
Lubrication Task
Check Headstock
Check Quick-Change
Gearbox
Check Apron
Bedways
Longitudinal Leadscrew
Ball Oilers
End Gears
Lubrication Amount & Type
Lubrication Task
Headstock
Quick-Change Gearbox
Apron
Bedways
Longitudinal Leadscrew
Ball Oilers
End Gears
-60-
Frequency Pg.
63
Daily
62
Daily
62
Daily
63
Daily
As Required
63
Before Use
Daily 63
Annually or
64
When Changed
Oil Type Amount
ISO 32
3.5 Qts.
(T23963)
ISO 68
1 Qt.
(T23962)
ISO 68
0.5 Qt.
(T23963)
ISO 68 As
(T23963) Needed
As
ISO 68
(T23963) Needed
1–2
ISO 32
Squirts
(T23963)
Brushed
NLGI #2
On
Items Needed
Hex Wrench 8mm .............................................. 1
Hex Wrench 6mm .............................................. 1
Phillips Screwdriver #2 ...................................... 1
2-Gallon Catch Pan ........................................... 1
Narrow-Neck Funnel.......................................... 1
8" Section ⁄ " NPT Threaded Pipe ................... 1
3
8
Brushes ................................................2 or More
Pump-Type Oil Can (Plastic or Rubber Tip) ...... 1
Shop Rags ......................................... As Needed
Mineral Spirits .................................... As Needed
NOTICE
The recommended lubrication is based on
light-to-medium usage. Keeping in mind
that lubrication helps to protect the value
and operation of the lathe, these lubrication
tasks may need to be performed more fre-
quently than recommended here, depend-
ing on usage.
Failure to follow reasonable lubrication
practices as instructed in this manual could
lead to premature failure of lathe compo-
nents and will void the warranty.
Headstock
Oil Type .... Grizzly T23963 or ISO 32 Equivalent
Oil Amount .......................................... 3.5 Quarts
Check/Add Frequency ................................. Daily
Change Frequency ....................... Semi-Annually
The headstock gearing is lubricated by an oil bath
that distributes the lubricant with the motion of the
gears, much like an automotive manual transmis-
sion. Change the oil after the first 2 hours of use,
then semi-annually.
Model G0750GV (Mfd. Since 03/18)
Qty