Grizzly G0750GV Owner's Manual page 7

Tailstock
S
T
R
X
Figure 3. Tailstock controls (rear).
Figure 4. Tailstock controls (front).
R. Quill Handwheel: Moves the quill toward or
away from the spindle.
S. Graduated Scale: Indicates quill movement
in increments of 0.001" with one full revolu-
tion equaling 0.100" of quill travel.
T. Tailstock Lock Lever: Secures the tailstock
in position along the bedway.
U. Quill Lock Lever: Secures quill in position.
V. Quill: Moves toward and away from the
spindle and holds centers and tooling.
W. Tailstock Offset Screws: Adjusts the
tailstock offset left or right from the spindle
centerline.
X. Offset Scale: Indicates the relative distance
of tailstock offset from the spindle centerline.
Y. ⁄ " Square Drive Lock-Down: Use with
1
2
a torque wrench for precise alignment of
centers.
Model G0750GV (Mfd. Since 03/18)
Control Panel
U
V
W
Z. RESET Button: Glows red if machine enters
fault mode or has a short circuit. Resets
machine functions when pressed in.
AA. Power Button: Press to turn machine ON.
Illuminates when lathe controls are receiving
power.
Y
AB. Emergency Stop Button: Push to stop all
machine functions. Twist clockwise to reset.
W
AC. Variable Spindle-Speed Dial: Changes
spindle speed within set speed range.
AD. Jog/Inching Button: Starts forward spindle
rotation as long as it is pressed.
End Gears
End
Gears
Configuring the end gears shown in Figure 6 will
control the speed of the leadscrew for threading
or the feed rod for power feed operations. The
rotational speed of these components depends
not only on the end-gear configuration, but the
spindle speed as well.
Z AA AB AC AD
Figure 5. Control panel.
Figure 6. End gear components.
-5-