Advertisement
From the 16-pin harness with
stripped leads
(included with interface)
• Connect the White wire to the left
front positive speaker output of the
aftermarket radio.
• Connect the White/Black wire to the
left front negative speaker output of
the aftermarket radio.
• Connect the Gray wire to the right
front positive speaker output of the
aftermarket radio.
• Connect the Gray/Black wire to the
right front negative speaker output
of the aftermarket radio.
INSTALLATION INSTRUCTIONS FOR PART AX-ADGM01
Installing the Interface
Only make the following connections
if the vehicle contains a digitally
amplified system
• Connect the Green wire to the
radio's left rear positive
speaker output.
• Connect the Green/Black wire to
the radio's left rear negative
speaker output.
• Connect the Purple wire to the
radio's right rear positive
speaker output.
• Connect the Purple/Black wire
to the radio's right rear negative
speaker output.
From the 22-way harness:
The Black/Yellow wire will be
discussed later on in the instructions.
The DIN plug is not used in this
application.
From the 30-way harness:
• Connect the Black wire to the
ground wire of the aftermarket radio
• Connect the RCA's to the AUX in on
the aftermarket radio (if equipped)
• Satellite information will be
displayed on D.I.C.
• Connect the Yellow wire to the con-
stant wire of the aftermarket radio.
• If the vehicle is amplified disconnect
the 4-pin harness located between
the 30-way and 22-way connector
and connect the supplied 4-pin to
4-pin resistor pad.
Only make these connections if you
do not have a digital amplifier
Amplified vehicles:
• Connect the Violet wire to the
right rear positive wire of the
aftermarket radio.
• Connect the Violet/Black wire to
the right rear negative wire of the
aftermarket radio.
• Connect the Green wire to the
left rear positive wire of the
aftermarket radio.
• Connect the Green/Black wire to
the left rear negative wire of the
aftermarket radio.
Non-amplified vehicles:
• Cut the resistors from the Green,
Green/Black, Purple, Purple/
Black right below the heat shrink.
• Connect the Violet wire to the
right rear positive wire of the
aftermarket radio.
• Connect the Violet/Black wire to
the right rear negative wire of the
aftermarket radio.
• Connect the Green wire to the
left rear positive wire of the
aftermarket radio.
Advertisement
