Axxess AX-ADXSVI-GM1 Installation Instructions

AX-ADXSVI-GM1
APPLICATIONS
BUICK
Enclave 2008-up
Lucerne 2006-2011
CADILLAC
Escalade 2007-2011
(only to be used when replacing an
amplified system)
DTS 2006-2011
(only to be used when replacing an
amplified system)
SRX 2007-2009
(only to be used when replacing an
amplified system)
CHEVROLET
Avalanche 2007-up*
Captiva Sport 2012-up
Cheyenne 2012-up *
Equinox 2007-2009
Express 2008-up
Impala 2006-2013
Impala limited 2014
Monte Carlo 2006-2007
Silverado 2007-13*
(new body)
Silverado 2500/3500 2014 *
Suburban 2007-2014*
Installation Instructions for AX-ADXSVI-GM1
Tahoe 2007-2014*
Traverse 2009-up
GMC
Acadia 2007-up
Savanna 2008-up
Sierra 2007-13*
(new body)
Sierra 2500/3500 2014*
Yukon/XL 2007-2014*
HUMMER
H2 2008-2009
PONTIAC
Torrent 2007-2009
SATURN
Outlook 2007-2010
Vue 2008-2010
SUZUKI
XL-7 2007-2009
*Non-navigation models only
• Provides accessory (12 volt 10 amp)
• Retains R.A.P. (retained accessory power)
• Used in non-amplified systems or when replacing amplified system
• Provides NAV outputs (parking brake, reverse, and V.S.S.)
• Prewired ASWC-1 harness included (ASWC-1 sold separately)
• High level speaker input
• USB updatable
Note:
1) This harness must be used in conjunction with the AX-ADXSVI
2) All chimes will be lost when using this harness
WIRING THE AX-ADXSVI-GM1
• Connect the Yellow wire to the radio's 12 volt battery or memory wire.
• Connect the Black wire to the radio's ground wire.
• Connect the Red wire to the ignition wire of the aftermarket radio.
• Connect the Orange wire to the illumination wire of the aftermarket radio. If the
aftermarket radio has no illumination wire, tape off the Orange wire.
• Connect the Blue wire to the antenna turn on wire of the aftermarket radio.
• Connect the White wire to the left front positive speaker output of the aftermarket radio.
• Connect the White/Black wire to the left front negative speaker output of the
aftermarket radio.
KIT FEATURES
(continued on next page)